How to Replace a Tub

It's big, bold and is the focal point of most bathrooms. It is the bath tub, and you will be surprised what a new one can do for your home. Installing a bath tub can be quite a project even for an experienced carpenter. Finishing the project will require the services of a professional plumber when connecting the water supplies and piping.

Step One

Before disconnecting any of the existing piping to the current tub, turn off the water to the bath tub. This is a step some homeowners forget to do and it can cause major headaches with home flooding.

Step Two

Once the water is disconnected, remove the old tub. This likely will be a two person job and will require a hacksaw for cutting the piping to the tube. When the old tub has been removed check the tub supports on which the tub rests for any water deterioration. If they are in good condition continue with the new tub's installation.

Step Three

Place the new tub on the supports and level accordingly. The new tub must also align with the existing walls, plumbing and drain. Try to have your plumber on site on the day of the installation, so they can professionally install the required connections to your faucets and drain. When this is done, turn the water back on to check for leaks.

Step Four

Fill the tub with water to check for any leaks when it is under pressure from the added water weight. If there are none, it is time to move on to put the finishing touches on your job. Use a caulking gun to place caulking between the wall and the floor to provide a waterproof seal.

Since you have properly installed your new tub, it will provide years of service and beauty to your bath décor.