Previous Article

How to Repair Exterior Door Trim

Next Article

How to Clean Exterior Wood Doors

How to Replace an Exterior Door Threshold

The threshold of a door gets all the traffic coming in and out. This is especially true an exterior door. Everything coming inside the house goes over that threshold. It receives constant temperature variations, traffic, moisture, friction and vibration. Once they become worn, they should be replaced and it is easy to do.

What you will need:



  • Knee pads

  • Protective glasses

  • Gloves

  • Tape measure

  • Hack saw

  • Screws

  • Screwdriver

  • Drill and drill bits

  • Caulk and caulking gun 



  1. Open and secure the door with a doorstop. (Use a chair or a rock or whatever to hold the door open.)

  2. Wear your protective glasses, gloves and kneepads.

  3. Take care not to damage the frame and remove the old or damaged threshold.

  4. Measure the doorway and cut your new threshold to fit. Use the saw and be careful not to cut it too short or angled.

  5. Place the threshold in the doorway making certain it fits correctly. If it feels uneven, you should place shims underneath where needed.

  6. Prior to placing the threshold check to see if there are holes for the screws to tie it down. If not you should drill some. Make sure they are centered on the threshold. At this time, screw it down well.

  7. Put caulk in any places that may need it. This will keep the air from coming in under or around the sides of the threshold.

  8. Once you have replaced your old threshold with the new one your door should swing open and shut with just a small drag on the door as it hits the threshold. This means you have a tight seal and the threshold is doing what it should.