Previous Article

How to Remove Door Panels on a Chevrolet Cavalier

Next Article

How to Change Tires on the Chevrolet Cobalt

How to Replace the Ignition Switch in a Chevrolet Cavalier

Electric current is routed to the starter through the ignition switch. The Chevrolet Cavalier has an easy ignition switch access point located in the steering column. A faulty switch will not allow the engine to start. The labor charge to replace an ignition switch is more expensive than the actual replacement part, but can be avoided. 

Items Needed: 



  • Ignition switch

  • Phillips head screwdriver

  • Plastic bowl



  1. Purchase the proper ignition switch from an auto parts supplier.

  2. Park the Chevrolet Cavalier on a flat surface and allow the engine to cool before replacing the ignition switch.

  3. Set the parking brake and scotch at least one tire with a brick for safety.

  4. Raise the hood and disconnect the battery cables.

  5. Locate the steering wheel cover and turn the screws that connect the cover to the base with a Phillips head screwdriver.

  6. Drop the screws into the plastic bowl for safekeeping.

  7. Place the two pieces of the cover in the passenger seat.

  8. Examine the steering column to locate the ignition switch.

  9. Remove the wiring harness from the back of the switch by holding the locking tab up and sliding the connector out. 

  10. Disconnect the switch by removing the two connecting screws and place these screws in the plastic bowl.

  11. Tug the switch utilizing both hands to separate it from the steering column.

  12. Dispose of the old ignition switch properly.

  13. Align the new switch with the steering column over the screw holes.

  14. Hold the new ignition switch with one hand, while tightening the screws with the other hand.

  15. Utilize the Phillips head screwdriver to tighten the screws.

  16. Connect the wiring harness to the back of the replacement switch.

  17. Press the connector into the back of the switch until if snaps into place.

  18. Position the steering column cover in place and replace the screws.

  19. Utilize a Phillips head screwdriver to tighten the screws.

  20. Reconnect the battery cables and shut the hood.

  21. Remove the block that is scotching the tire and put away tools and discard paper.

  22. Place the key in the ignition switch and crank the car. The Chevrolet Cavalier should start without further problems.