How to Reset a Chrysler Town & Country Key Fob
The Chrysler Town and Country comes with a FOB remote key entry. The FOB key system allows you to lock, unlock, open the trunk, set off the car alarm, and start the vehicle remotely. An issue may develop with the FOB key that causes it to need reprogramming.
You can complete the reprogramming of the Chrysler Town and Country FOB key by following the guidelines. In rare cases, this process may not work and the service department will need to complete the process for you.
- Check the remote FOB key to ensure
it has an operational battery by pressing the “Lock” and “Unlock”
button. - Push the “Lock” button every
two seconds for a total of five times. - Place the key into the ignition
and turn it to the AC position. Be careful that you don’t turn the
key far enough to start the Town and Country. - Wait for the car to stop chiming
before proceeding to the next step. - Press the “Unlock” button and
hold down for 10 seconds. - After holding the “Unlock”
button down for five seconds press the “Panic” button and
continue to hold both buttons down for two seconds. - The remote will chime informing
you that the remote is in programming mode. - Press and release the “Unlock”
and “Lock” buttons at the same time. - Press the “Unlock” button and
you will hear a chime alerting you that the FOB key has completed
the reprogramming. - Turn the key to the "Off" position and remove the key from the ignition
to complete the reprogramming process.