Previous Article

Features of the Lexus 350

Next Article

Features of a 2006 Lexus Convertible

How to Reset the Lexus 350 Maintenance Required Light

When the Lexus 350 has gone 3,000 to 5,000 miles, it will require an oil change.  Depending on the exact mileage, other services may be required or advised to keep the vehicle in good, running condition.  As a reminder of these needs, there is a "Maintenance Required" light that will turn on when the time has arrived for this work to be done.

The Maintenance Required light is different from the Check Engine light and the two should not be confused.    The Check Engine light is reset using different procedures than the Maintenance Required light.  After you make sure that the required maintenance has been performed, you will need to reset the Lexus 350 maintenance required light.  Follow these steps to do that:



  1. Put the key in the ignition.

  2. Turn the ignition switch to the ON position.
    This lets the accessories run without the engine being on.  It is two clicks forward in the ignition switch.

  3. Set the Trip button to zero.
    This is done by holding the Trip reset button down until it resets.

  4. Turn the ignition switch to the OFF position

  5. Hold the Trip reset button down while turning the ignition switch to the ON position

  6. Watch for the Service Maintenance Reminder light to go through a series of flashes
    For 3 seconds it will stay lit
    For 2 seconds it will blink
    For 1 second it will stay lit
    The light will then turn off
    If the light continues to blink, turn the ignition to the OFF position and repeat this procedure from step 1

  7. Take your finger off the Trip reset button, thus releasing it

  8. Turn the ignition switch to the OFF position

  9. Turn the ignition to the ON position to test that the Service Maintenance Required light has been reset.