Previous Article

How to Replace Galvanized Plumbing

Next Article

How to Get Free Information on Plumbing Codes

How to Run Bathroom Plumbing

Running bathroom plumbing includes constructing incoming freshwater pipes, and outgoing waste drainpipes. The type, size and codes determine the types of materials and methods necessary for pipe installation. Toilets, sinks and showers require incoming and outgoing plumbing that is up to building codes in order to pass inspection.

Items Needed:



  • PVC Pipes and fittings

  • PVC Couplers

  • Saw

  • Cement

  • Primer

  • Drain pipe

  • Tape measure

  • Pen and note book

  • Personal protective equipment including gloves, mask and goggles



  1. Measure the bathroom noting the positions of the toilet, sink and shower drains.

  2. Brush up on plumbing codes available in books, libraries, online and local building and inspections offices. Building codes instruct plumbers of the proper installation methods and materials for residential construction. These codes ensure the safety of the home and neighborhood.

  3. Apply for the permits if allowed, or hire a master plumber with licensing and certification. Master plumbers pull permits and ensure the system passes inspection. 

  4. Determine the parts list based on the dimensions, codes and appliances to be installed. Create a parts list using the measurements, and the draft or blueprints for incoming water pipes and drainage pipes in the bathroom. Purchase parts and tools at a home improvement store.

  5. Cut PVC pipe to the appropriate length of the intended appliance stub-in. Determine the couplers necessary to complete the connection.

  6. Apply PVC primer around the stub-in pipe and the pipe and connect the two ends. Apply PVC cement on the joint pieces and hold together for about 30 seconds.

  7. Measure and cut out the pipes leading to the shower, toilet and bathtub. Cut the pipes to fit each distance individually, and attach connectors. Apply primer and cement to join all the pipes.

  8. Cut a hole in the floor and on the wall, where you will position the toilet flange. Use screws to attach the flange.

  9. Fit the drain line, and connect it using primer and cement. Place the drainpipes in a sloping position and use supports every 30 inches. Connect drainpipe to the tub, shower and sink, then apply PVC cement and primer.