How to Set a Hot Water Tank
According to the U.S. Department of Energy, operating your hot water tank above 120 degrees Fahrenheit burns excess energy and cost you more money. By setting your tank to 120 degrees Fahrenheit you cut your cost by 6 to 10 percent, as well as extend the life your tank.
What You'll Need:
- Screwdriver
Gas Hot Water Tank
- Find the thermostat knob, its generally located toward the bottom of the tank. There are usually no covers over the thermostat.
- Figure out the current setting. A warm setting is typically in the lowest range, between 90 degrees Fahrenheit and 110 degrees Fahrenheit. A hot setting is in the highest range, between 140 degrees and 150 degrees.
- You can turn the temperature adjusting knob to the desired setting.
Electric Hot Water Tank
- Turn off the circuit breaker in your home in order to shut off the electricity to the hot water tank.
- Find the tank's thermostat. If you have a single heating element, the thermostat is generally found near the bottom of the tank. Tanks with double elements will generally have one thermostat at the top of the tank and one at the bottom.
- Take off the two screws that hold the thermostat cover in place and remove the plate and insulation covering.
- See where the indicator is pointing on the rotating dial to read the proper temperature. The thermostat adjusting screw is usually found just above the element at the bottom of the thermostat. You'll need to use a screwdriver to adjust the temperature to your desired level.
- Repeat steps three and four to set the bottom thermostat on a double-element tank.