Previous Article

How to Replace Electrical Service Panels

Next Article

How to Start an Electrical Service Business

How to Size a Building's Electrical Service

It's not actually difficult to get a reasonable determination or sizing of a building’s electrical service. Abiding by the code requirements and having a good knowledge of amps and volts is a must. Visual inspection and use of digital multimeters (DMMs), Volt-ohm meters (VOMs), neon testers, and electrical inspection safety are used in conjunction with other methods to size a Building's Electrical Service requirements or estimated usage of the electricity.


  1. Indicate the building’s classification choosing from commercial, residential, sub-residential or industrial buildings.

  2. Specify the base capacity. According to the National National Electrical Safety Code (NESC), the base capacity must have a minimum number of amps in a residential dwelling.  Sub-residential restrictions are minimal but they still must comply and plan for estimated usage of electricity and amperage.

  3. Make visual inspections and determinations allowing adjustments for pools, heated
    spas and other large load amenities such as air conditioning units or additional
    compressors and units that would require additional electrical panels. The
    addition of one or more large loads requires an increase in the electrical
    capacity.

  4. Calculate the demand factor which is the ratio of the load that a piece of equipment actually draws when it is in operation to the load it could draw.

  5. Determine what the diversity factor will be. The diversity factor is the probability that a particular piece of equipment will turn on at the time of the facility's peak load.

  6. Consider ampacity when determining service. This item is the rating of the electrical meter base and the meter itself.  Often, there is no concrete way of determining this rating on a visual inspection for sizing a building’s electrical service since the rating sticker would typically be inside the meter base and would require pulling the meter off to see it. There are basic guidelines that electrician’s will use for determination.