How to Tighten Plumbing Fittings
The plumbing fittings are a very important part of the plumbing system. If these fitting are loose, leaks and other issues can occur within the plumbing system. You can learn how to properly tighten your plumbing fittings by following a few simple steps.
- Locate the plumbing fittings on your plumbing device. These fittings are located where the pipes connect within the plumbing system.
- Use a wrench to tighten the fittings by moving them to the right. Turning the fittings to the left side will cause them to become looser.
- Be sure not to tighten the fittings to tight. Although it may seem like they’ll be less likely to leak water if they are tighter, very tight fittings are actually more likely to leak water because the rubber seal inside the fitting will become warped.
- Only tighten the bolts on a rare occasion. Tightening the fittings too often will cause the bolts to become stripped and they will then be difficult to tighten or loosen and can cause problems for the plumbing system.
- Place plumbers tape around the fittings if you are unsure if they are being tightened too much. This tape is made from silicone and prevents the bolts from becoming too tight.
- Use magnetic insulation on any plumbing pipes that are located outdoors. You want to place the insulation directly on the fittings. The insulation will keep the pipes warm and prevent the fittings from becoming loose when they are exposed to cold weather condition.