Previous Article

How to Make Your Own DVD Storage Racks

Next Article

Basement Storage Room Ideas

How to Weld Storage Racks

The storage of various items can be difficult, due to their weight and need for stability. The best way to stabilize the racks is to weld them. They are not only stronger, but significantly less flammable and better suited to the storage of certain items.


 

What you will need:


Chop saw, 1/8-inch by 2-inch angle iron four feet in length (6-8), 1/8-inch by 2-inch angle iron five to six feet in length (4), sheet metal 2x4 or 3x4 (3-4), 1/8-inch by 2-inch angle iron two to three feet in length (9-12), welding safety equipment (helmet, gloves, protective clothing), clean cloth, acetone, right angle grinder, coarse wheel, rust-proof spray paint


Welding the racks:



  1. Decide on the dimensions you will need for your storage racks. This includes the height, width, and depth of the shelving.

  2. Cut your metal to the dimensions you have pre-determined that you will need using a chop saw, which will make your shelves. Your shelves should be two to three feet deep and about four feet in width.

  3. Set the ends of the four-foot shelves to forty-five degrees. The shorter pieces (all but four of them) need to be mitered to forty-five degrees. Make sure that the height of the shelf frame pieces are flush when welded together. 

  4. Place one of the sheet metal pieces across sawhorses or a table designed for welding. Place down two of the four-foot long angle iron onto the long sides. Make sure that the length-wise face of each of the pieces is flush with the sheet metal's outer edge. The horizontal parts should be directed towards each other. Put two of the shorter pieces of metal on the shorter sides in the same manner.

  5. Put on a welding helmet and safety equipment. Weld the iron into place. Repeat step four and this step until all of the shelves you need have been made.

  6. Put a mark on each of the five or six feet angle iron pieces at two inches from one of the ends and six inches from the opposite end. This will be the positioning of the bottom end of the top shelf and the top part of the bottom shelf.

  7. Using this same method, mark the positions for each other shelves. They should be spaced according to your needs. You will then need to clamp these parts onto the top and bottom shelves. Make sure to adjust the positioning of the shelves until the lines are flush. Then weld the parts into place.

  8. Examine your welding while the shelf is in a standing position. You can grind off any splatter from the weld for a more polished look. Use acetone and a soft cloth to wipe the shelf clean. If you want to paint the shelf, use rust-proof enamel paint.