How to Wire a Circuit Breaker Panel
Most people are afraid to wire a circuit breaker in their homes because they believe it's dangerous. The purpose of a circuit breaker is to divide the electrical load equally to prevent circuit overload and potential electrical fires. A circuit breaker panel is a required safety device in every home. With basic knowledge, you can install a breaker panel in complete safety.
Materials:
- Circuit breakers
- Marking pen
- Cable clamps
- Channel locking style pliers
- Screwdriver
- Ground rod
- Ground clamps
- Ground wire, ten gauge
- Utility knife
- Wire stripper
Procedure:
- Understand the basics of how a circuit breaker works.
- Shut off the main power supply to the home before installation.
- Punch out holes in the box with your screwdriver for the cables from the power company.
- Grip cable clamps to the holes, tightening with the channel locks.
- Feed the cables through the cable clamps. Secure with screwdriver.
- Examine the two bus bars. One is brass and one is silver. The red and black cables connect to the brass bus bar. The white cable connects to the silver bus bar. Ground the silver bus by tightening with screw driver until it firmly connects with the ground bus.
- Pound the ground rod into the soil. Extend the ten gauge ground wire to the rod securing with the ground clamp. Attach the wire to the ground bus.
- Count how many circuit cables are needing to be inserted into the breaker box. You can run more than one circuit into one hole.
- Punch out enough holes to accommodate the circuit cables. Tighten each clamp with a screwdriver.
- Remove around eight inches of sheathing from the wires. Attach the white wire to the silver bus. Attach the bare wire to the ground bus.
- Connect the black wire to the lug on the circuit breaker. This lug should be hot. Mark its location on the door panel--kitchen, bathroom, den, etc. Red and black cables are connected separately to their separate 220 double gang-breaker lugs.
- Secure the breaker into its available slot.