Previous Article

Repairing Siding

Next Article

Installing Wood or Fiber-Cement Siding

Installing Vinyl Siding

If you are looking for a low-maintenance way to revitalize the exterior of your home, the answer may be to install vinyl siding. Vinyl siding is one of the most popular choices in siding in the United States, due to the fact that you do not have to re-paint it, it will not crack and peel and it can weather the elements. When installed properly, vinyl siding can be your home's best friend.

History


Around since the 1950's, vinyl siding slowly made its way on home's exteriors. After twenty years of testing and through many manufacturing engineering changes, vinyl siding's popularity quickly grew. With many color choices, textures and patterns to choose from, homeowners were starting to catch on to how versatile vinyl siding could be. At that time a home was made of wood and needed yearly maintenance. On wood siding, maintenance included painting, refinishing, and scraping it, to keep it looking new. Additionally, if too much moisture would get into the siding, wood siding would rot or mildew, or even worse deteriorate from insect infestations.


Average Costs


As mentioned, there are many different textures and patterns of vinyl siding to choose from. Therefore pricing can vary significantly with different brand specs. The average price for vinyl siding ranges from $3 to $9 a square foot. The typical home has an average exterior square footage of approximately 2500 feet. Another factor, which may play into the price of the siding, is the thickness of the siding. The average thickness of vinyl siding is about .46. Without installation costs, you can figure the average cost of a job this size and with these configurations will run about $10,000. Installation costs, depending on where you are located will range from $2,000 to $5,000. However, if you know a little about carpentry, you may be able to install it yourself.


Installing vinyl siding


Materials needed:



  • Unlocking tool

  • Snaplock punch

  • Nail hole punch

  • Siding

  • J-Channel

  • Undersill trim

  • Starter strips

  • Siding nails

  • Chalk line


Always follow the manual, which came with the siding. There are many manufacturer brand variations and some manufacturer's siding kits may come with the basic tools listed above, such as J-Channels or starter strips. The guide below is a basic way to complete vinyl siding installation.



  1. Use a chalk line as your guide. Nail the starter strips around the bottom of the exterior. Leave 1/4" for the ends to lock together.

  2. Install the corner posts. Keep the same 1/4" rule in mind when installing the posts.

  3. Install the J-Channel on the doors and windows.

  4. Install the under-sill trim

  5. Begin by lightly nailing the center slots of the siding to allow for adjusting the siding to the right or to the left. You are only lightly nailing the pieces to allow for adjustments as well. Overlap the panels by 1" on each panel joint.

  6. On doors and windows you will need your punch edge to notch channels for lugs.