Previous Article

Installing Metal Roofing

Next Article

Installing Copper Gutters

Installing and Repairing Gutters

Gutters help protect your home from water damage when it rains. Gutters allow the water to run off the roof and be diverted away from your home. These are easily installed.  If there is any damage to your gutters, the gutters will not work properly. Finding the issue with the gutters and repairing them is inexpensive and fairly easy.

Preparing:



  1. Measure: Measure the edges of the roof. Gutters are available in 10 foot sections, so determine how many sections you need. For example: if your roof is 52 foot long, then you will divide that by 10, so you need 6 sections, which will give you 8 foot extra. It is always better to buy more than you need, as some pieces may need to be cut.

  2. Plan: Plan the layout of your gutters. Determine how many mounting brackets, elbows, downspouts, corners and end pieces that you will need. 


 


Installing:



  1. Start at the end away from where the downspout is going to be. Measure 1/2 inch down from the edge and mark it. Then, go to the end where the downspout is going to be; measure 1/2 inch down from the edge and mark it. Using a string level, ensure that these two marks are level with each other. If the marks are not level, adjust so that the marks are level.

  2. Determine the slope that you are going to need, as you want to ensure that the water flows toward the downspout. For every 10 feet of gutter, there should be a 5/8 inch slope. From the end where the downspout will be, measure 5/8 inch, from the 1/2 inch mark.

  3. Make a chalk line from the lower mark to the mark at the other end. This line will guide you on where to hang your gutters.

  4. Install the mounting brackets, drop ends, corners and other components. This should be done using a screwdriver bit on a power drill and rust-resistant screws.

  5. Install each section of gutter. Place each section into the mounting brackets. Use connectors to join the sections together.

  6. If you need to cut a section of the gutter, use a hacksaw.

  7. It is advisable to use caulk in between the gutter sections. This will keep water leaks at the seams.

  8. At the bottom of the drop end, install an elbow. Measure and cut the downspout. Install the downspout.

  9. Attach the downspout to the house with mounting brackets.


 


Repairing:



  1. Inspect: Inspect the gutters to see where the problem lies.

  2. Assess: Once you have determined where the problem lies, decide whether you should repair or replace the gutter. If the gutter is badly damaged, it may be best to just replace that section, rather than repair. Examples are: warped gutters, multiple holes in the section or melting.

  3. Repair/Replace: Dry the area that is leaking, whether it is the joint or the connection. The connection may need to just be tightened. If it is damaged, then it can be replaced. Use caulk to ensure there are no more leaks around the seams. 

  4. Fix Holes: In all kinds of gutters, except aluminum ones, the entire section of gutter will need to be replaced. For aluminum gutters, use flashing to patch the hole. Cut the flashing one inch bigger than the hole on each side. Use roofing cement to attach the flashing to the gutter, from the inside. Press it into place.