Previous Article

Installing an Oil Boiler or Radiator

Next Article

Repairing a Radiator Heating System

Repairing an Oil Boiler

An oil boiler is one appliance that is durable. A properly maintained oil boiler can last up to 20 years. However, there are times when it may present some problems, most of which can be solved easily by the homeowner.

Not Starting: 


Press the "reset" button one or two times. If the boiler does not come on within one minute, check the fuses and the circuit breaker.


No Fire, But Running Burner:


 



  • Check the nozzle on the burner. It is very small and can become clogged with either water or trash. It can be replaced very cheaply and may be the solution. 

  • Check the transformer, it may have a short. Disconnect the wires, all but the ones that run to the transformer. Using a screwdriver that has an insulated handle, touch the end of the screwdriver to one terminal, then lower it to touch the other terminal. If the arc created is less than 3/4 inch, the transformer should be replaced.

  • Check the electrodes for cracks or dirt. This can keep the boiler from running, too.





Fire, Running Burner, But Little to No Heat from the Registers: 



  • Check the filter. If it looks dirty, make sure to replace it. A dirty filter can prevent airflow.

  • Check the fan belt. It could be broken. It is behind the air supply fan's inspection door. Replace, if broken.

  • Check the air supply fan. Occasionally, these do burn out and need to be replaced.

  • Check the ductwork. Ductwork that is left loose, has come loose or disconnected could be the problem. You can fix it with some duct tape and purchasing replacement parts for those that may be corroded. It also may be necessary to insulate the ductwork.


Oily Smell, Soot or Smoke Coming In the Registers:



  • Check the combustion chamber. If it is too hot when placing your palm near the opening, it could be blocked.

  • Check the chimney and the flue for blockage.

  • Check the gaskets around the door to the combustion chamber. It may be cracked or warped, which will allow smoke to escape and then be sucked into the house.

  • Have a technician check the internal gaskets that are on the heat exchanger.