Steps to Making Roll Bars
Roll bars are designed to reduce the amount of sway in your vehicle. They can correct the vehicle during turns and is important to keeping the vehicle on the road. If you make your own roll bars, be careful to follow all instructions. This article will cover steps to making roll bars.
Steps To Making Roll Bars
You will need a tape measure, steel pipe, pipe cutter, vise, brace, welder, bending tool, drill, nails, sand, and car paint.
Measure from the top of the vehicle to the bottom of the rear window. Also measure along the rear of the vehicle. You must have enough steel pipe to cover those measurements. You should have two lengths that are the height of the vehicle and one length that is the width of the vehicle.
Cut the each steel pipe according to the measurements you took in step 2.
Place one end of the pipe into a brace and the other end into the vice. 2 1/2 feet of pipe should extend out of the vise. Heat the area near the vise and hold the other end with the bending tool. Bend the pipe into a 90-degree angle.
Lay the pipes out so they form two L's. The short pipes should be at the opposite end. Drill a hole into the ends of the short pipes. Push the screws through each long parts of the L pipes. You should end up with an 8 shape. Place the short bars onto the ends of the L bars with screws and add the nuts. Sand down the roll bars and paint them. Install them in the vehicle.