Previous Article

Tips About Safely Wiring a Garage

Next Article

Tips About Tiling Over Linoleum

Tips About Stair Construction

There are a number of reasons to build your stairs yourself. You can be sure of getting exactly the stairs you want. Because the process is labor intensive, you will save a good deal of money. There are a number of places to go wrong when building stairs, though. Learn some tips to keep you on the right track.

A home with more than one level needs steps or stairs of some sort. The building process is not complicated, but both the math and the construction have to be done right to avoid wobbly, squeaky stairs. Follow these steps to make your stair building efforts a success.



  • Check local regulations before the building process begins. There may be requirements for width and slope that you must meet. If you are planning anything unusual, get the building inspector to sign off on it before construction begins.

  • Do the math carefully. You have already looked up the building code’s maximum rise per step (probably 7 ½ inches) and minimum width per tread (usually 10 inches). Now divide the measured distance from the floor at the bottom to the floor at the top by the desired rise per step. For this purpose, count any landings as a step. You will almost assuredly get an uneven number, probably between 12 and 14 for standard ceiling heights. Do not be tempted to make any one step different from the others, not even the landing. Instead, divide the same distance by the whole numbers on either side of your result. If both are in the legal range, choose the one that looks easier to measure.

  • Measure even more carefully. If you will cut your stringers, make a full size pattern of the cuts for tread and riser. Make sure the top surface is level, and then snap a line to run through the bottom corner of all the cuts. Draw all the lines directly on all the stringers. Lay them out side by side and make sure they match. Make sure the ends are at just the right angles to fit snugly at top and bottom. Lay out the risers, treads and scabs if you use them with equal care.

  • Cut carefully, too. You will either cut or groove the stringers themselves to accept the treads and risers or screw and glue scabs to the risers to support the other parts. In any case, make sure to cut them exactly to size.

  • Assemble the staircase with precision. Make sure each part goes exactly where it is meant to go. If there are any minute gaps, shim them, or your staircase will creak.


Anyone who can build a house or an addition can build a set of stairs. The skills are similar; only the extreme care in layout and measurement differs. All it takes to build an attractive and useful flight of stairs is a little attention to detail.