Tips for High-Speed Cable Connections
When installing coaxial cable it doesn’t take much to either slow down the connection or end up with poor picture quality in your web travels. The actual connections should be made very carefully and how the cable is run will make a difference. Follow a few steps and prevent this from happening to you.
- Do not buy or use cheap cable. When you get cheap you get low quality results. The shielding in the cable is what protects the signal. You need to have a “quad-shield” cable that costs about twice what others cost, but they are most certainly worth the difference.
- Be careful not to kink your cable in any way. Kinking would also be taking it around any sharp corners as well. You do not want the molded foam inside to become crushed. It should not be bent in a smaller radius than three inches.
- Keep all the coax at least six inches away from all electric lines as they may cause interference. This is true even in they are separated by wood in the structure. It is a good idea to not get the coax close to phone lines as well.
- Staple the coax if necessary with staples made for coax and there are a few. Be sure not to drive them in too far as they will crush much as in the ‘kinking’ discussed earlier. It is best for the cable to be a bit loose rather than crushed.
- Do not nick the center wire. What is not commonly known is that the signal travels down the outside of the wire, not inside it. A tiny nick can really wreak havoc on your signal. Never use regular wire strippers on coax. There is a special coax stripper that should be used for placing the connectors on coax.
These are just a few tricks about enhancing your high-speed cable connection. There are many more. You can go online and it won’t take but a minute to find them.