Types of Door Brackets for Electrical Garage Door Installation

Mounting brackets for an electrical garage door opener hold the track and other accessories so that the door slides onto the wall and ceiling of the garage. They also evenly distribute the weight of the door. Badly worn electrical garage door mounting brackets may cause crimps, dents and flat spots in the track and should be replaced before resulting in damage to the internal electrical motor.

• Center bearing bracket: houses the shaft bearing, provides support for the torsion shaft including the spring assembly and anchors stationary cones to the header. Also called a spring anchor bracket.


• End bracket: includes a ball bearing to support movement of a torsion shaft at each end. Also called an end bearing plate.


• Inside hook-up bottom bracket: located between the vertical track and the door section where the cable is routed.


• Jamb bracket: used to join the vertical track to the door jamb and is “L” shaped.


• Low headroom operator extension bracket: cures excessive garage door overhang and practically eliminates damaging door rubs. The consumer may choose to install the low headroom operator extension bracket directly inside or offset the mount slightly. This allows full clearance for boats, vans and other tall items. Also called a quick turn bracket.


• Outside hook-up bottom bracket: located where the cable is routed outside the tracks in the bottom corner.


• Reverse angle mount: used to join the vertical track to the jamb in a low headroom and sideroom clearance garage. It is “L” shaped and utilized with the wall section toward the door opening.


• Roller bracket: holds the track roller and is attached to a door section.


• Safety bottom corner bracket: intended to thwart damage to the door from falls if the cable broke. Also called bottom roller bracket and broken cable device>


• Top roller bracket: positions the top guide roller on the top section of a door. Also known as a top fixture.


• Track bracket: an attachment designed for joining the track to the jamb.