Previous Article

The Best Plumbing Supplies

Next Article

How to Glue PVC Plumbing Pipe

Water Well Plumbing System Components

A water well plumbing system has a pump that delivers water from the well to a pressurized tank where it remains until it is needed. When a faucet is turned on, the water is forced out of the tanks and through the pipes by the tank's air pressure. A second tank is sometimes added as a bulk storage. It uses gravity to move the water and can be operated when there is a power outage.  

A well system brings water up from the ground into a pressurized tank. The tank retains the water until it is needed in the house pipes. Because the tank is pressurized, the pump does not have to run every time water is needed. The pump runs when the water drops below a specified level and shuts off once the tank is refilled and pressure is reestablished.


Pump


The most common well pumps are the submersible and jet types. A submersible pump is more efficient than a jet pump. It sits in the well and pushes the water up into the system. 
A jet pump is used for a shallow well and creates suction above the well to draw the water into the system. Jet pumps must be filled with water before they will work. This is referred to as "priming."


Storage Tank


The storage tank retains the water in a pressurized enclosure until it is needed. A tank
that has a permanent means to separate the air and water is known as a bladder or diaphragm tank. A plain steel tank is just that, and used most often for a secondary retention of water or bulk storage. These tanks are found installed next to the pressurized tank.


Pressure Switch


A pressure switch is used on submersible, jet and reciprocating pumps. It monitors the system's pressure, turning the pump on and off as needed to maintain pressure in the appropriate range. The low-end of the range is referred to as the "cut-in" number and the high-end as the "cut-out" number. It should be located near the tank for optimum monitoring efficiency.