Previous Article

About KitchenAid Dishwasher Repair

Next Article

How to Troubleshoot Dishwasher Repair

About Whirpool Dishwasher Repair

Like all appliances, troubles may arise with your Whirlpool dishwasher. Although some are costly and require you to contact the manufacturer for new parts, other problems are minor and may be repaired at home with a few simple troubleshooting techniques.


Troubleshooting



 


To troubleshoot and repair your Whirlpool dishwasher, you must begin by checking the obvious. Make sure the device is plugged into the wall. Do not forget to check your fuses or circuit breaker, if there is not any power going to the dishwasher.


If water is not flowing through the mechanism, try checking the water shut-off valve. Sometimes, the valve may be partially or fully open, which will prevent water from flowing to the dishes. Examine the dishwasher water valve, because it may be faulty and cause water not to distribute to the dishes. Clean the spray arms and the entire dishwasher using a special solution made for this purpose. Sometimes, debris and calcium buildup cause parts of the mechanism to clog.


On some occasions, the dishwasher may not drain the water. This could be caused by a drain solenoid, a broken pump or motor, a defective timer or a worn out belt. Check the drain hoses to make sure these are not clogged.



Replacing Parts



 


You might have to replace some of the parts on your Whirlpool dishwasher to repair it correctly. Some devices are found at your local hardware store, while other pieces, typically the larger pieces such as the motor, require you to order directly from the manufacturer.



Tips



 


Always unplug your dishwasher prior to repairing any mechanisms inside of the appliance. Check to see if your dishwasher has a recall. Usually you receive notification via email, by mail or by phone; however, if you missed the update you can always call or check online.