Previous Article

Checklist of a Concrete Work

Next Article

How Does Pre-Stressed Concrete Work?

DIY Concrete Work

DIY concrete work has taken on new interest with a lot of homeowners trying to save money. Laying a simple concrete slab for a walkway or a small patio does not require a lot of training or skills. You must follow mixing directions, and work quickly and efficiently before concrete sets up. A few tips about mixing and laying concrete may be just what you need to get started on a new project.

Items Needed:



  • Wheelbarrow

  • Shovel

  • Concrete

  • Wooden float

  • Wooden tamper

  • Spading tool

  • Trowels




  1. Measure the area for concrete forms, and build the forms to contain the concrete. Level the surface area before laying down the forms. Put the forms in place and have them ready to go before mixing the concrete.




  2. Use a wheelbarrow to mix the concrete according to package recommendations. A shovel works well for stirring, and mixing the concrete with water. Plan on using the concrete within 45 minutes of the time it is mixed. Extreme temperatures and sunshine can affect how quickly the concrete begins to harden. Wooden planks can be laid on the ground for the tires of the wheelbarrow to prevent damage to the pouring area as you work.




  3. Pour the concrete into your forms and tamp in place using a wooden tamper to remove air pockets. A spading tool or a wide board six inches across works well to level the pebbles on the concrete surface.




  4. Insert rebar in portions of the wet concrete if desired to add extra strength to the concrete depending upon the type of concrete project you are pouring. These should be measured and cut appropriately to be level with the concrete surface. Rebar should be inserted after the concrete has had a chance to stiffen slightly.




  5. Allow the concrete to set up so you can work with a finish if desired or just smooth the surface flat for walkways or a simple patio. Once the concrete is somewhat stiff, you can finish the surface with broom sweeping, sand floating or your choice of finishes.



  6. Let the concrete cure slowly if possible to avoid drying too quickly and cracking. Tarps placed across the concrete work well for slow drying. Cure the concrete slowly by keeping is slightly damp and providing protection from direct sun for about two weeks.