Previous Article

Drain and Sewer Cleaning

Next Article

Drain and Sewer Services

Drain and Sewer Fittings

Repairing drain and sewer fittings on your own can save you a lot of money. Before you get to work though, you need to know all about fitting, so you will have less of a chance of making mistakes. Fittings are pieces that hold the pipes together when the pipe takes a twist or a turn. They make sure that no water gets out


  • Pipes come in many shapes and sizes. Fittings too come in different shapes and sizes. You need to make sure you have the correct size fitting to get the job done right.

  • You need to decide what you want your pipefitting made of. They come in PVC (polyvinyl chloride), stainless steel or copper.

  • There are many types of fittings. There are round, male or female, plain end bell or socket, pipe clamp ends and ribs. This only names just a few. You need to find the one that best suits your pipe.

  • Pipefittings come in strength varieties too. It depends on the type of pipe you have and what will be running through them. 

  • Usually you need to match the material of the fitting with the material of the pipe.

  • Fittings are also be used for repairing cracks in the pipes.

  • You can find fittings at the local hardware or plumbing store. The cheapest fitting is made of PVC pipe.

  • Before doing any pipe fitting work, it is advised that you make sure that the water is shut off.

  • Once you have the pipe repaired, you will want to run a test to make sure you did it correctly. If not then you may end up paying a ton of money for water damage.