How To Make Leather Jewelry
Leather is great for making jewelry because it is one of the easiest stringing materials. Whether you want to design, finish, or create a leather necklace it just takes some basic materials. There are numerous kinds of jewelry you can create for your collection. You can even make gifts for your friends and family by making custom beads, charms and pendants.
Things you will need to create leather jewelry:
- Scissors
- Leather cord
- 2 crimp ends
- Jewelry glue
- Crimpers
- 2 jump rings
- Pendant, charms, or beads
- Round nose pliers
- Chain nose pliers
- Clasp
- Get some leather cord and cut it about a 1/2-inch shorter than you want when it is finished. An average length necklace for a woman is normally 17 to 19 inches. A bracelet is usually between seven and nine inches. Be sure to cut the leather at an angle that is suitable for easier stringing.
- Put some jewelry glue on the inside of the first crimp end. Take the leather cord and thread it into the end with the length of the leather going away from the loop on the crimp end. Be sure to crimp in place and cut excess leather that is remaining. Let the glue dry for several minutes.
- String the charms, pendants and beads on the leather cord from the non-crimped end. Be sure if any beads you use have a big hole to accommodate the leather but will be small enough to fit snug.
- Put a dab of jewelry glue to the other crimp and repeat step 2 with the other end of the bracelet or necklace.
- Open up the jump ring by holding either side of the opening with the two sets of pliers. Turn the pliers in opposite directions in order to open the ring. You will then have to string the loop from one end of the crimp and one half of the clasp on the jump ring. In order to close the ring, reverse the twisting motion. Do the same with the other jump ring, clasp and crimp end. Now you leather jewelry is ready to wear.