How To Use Tire Irons
Just about everyone can confess one story of being the victim of a flat tie. Many of these incidents could have been mitigated or even have been prevented or by applying a little simple knowledge of an old fashioned tire iron. Changing your tire can be tricky and a tire iron can mean the difference between success and an emergency phone call.
- Remove the center cap or hubcap that may be blocking access to the lug nuts. To remove the cap, simply pry along the edges with the lug wrench end of an old-fashioned tire iron until it loosens and you are able to remove it by hand.
- Loosen the lug nuts initially hidden by the wheel’s center/hub cap. Using the wrench end of the tire iron and making sure that the tire iron cap is completely and firmly pressed against the lug, turn the tire iron in a counter clockwise fashion. This step is done before any attempt to raise the vehicle off the ground.
- Check your jack placement. Before jacking up a few thousand pounds of car, make certain that the ground beneath your jack is both level and solid.
- Raise the car. The jack points on each vehicle can vary considerably; check your owner’s manual to determine the position on your car where your jack can be safely deployed. Once in place, insert the crank begin to raise the vehicle. Your goal is to have roughly a one-inch gap between the flat tire and the ground.
- Turning counter clockwise, remove the pre-loosened lug nuts. Now that your car is off the ground, to remove the nuts you loosened in the earlier step. Keep track of the removed lug nuts. Do not permit a lug nut to wander as they play a pivotal role in keeping your tire in place.
- Remove the flat tire. Place the newly removed to the rear of the vehicle.
- Attach your spare tire. Center your spare tire on the wheel studs.
- Using the tire iron, re-install your lug nuts on to the exposed wheel studs, turning the tire iron in a clockwise motion to tighten them. Do not attempt to tighten the nuts too drastically as the vehicle is still suspended via the jack and would pose the issue of falling off due to too much force.
- Lower your car to the ground. Moving the crank in a counter clockwise position, lower your car to the ground.
- Use the tire iron to tighten your lug nuts thoroughly. Now that the car is no longer in the air, you want to make certain the lug nuts are tight enough to hold your tire in place. The long arm of the tire iron provides the extra leverage needed to ensure a tight fit.
- Remove and store the jack and flattened tire and drive home.