Previous Article

How To Use Tire Irons

Next Article

How to Use Touch Up Paint

How To Use Tire Spoons on a Car

Removing tires from wheels can require muscle and dexterity. Amateur mechanics are often advised to use pry bars to help get the tire off, often with the addition of cheaters for additional leverage. Unsurprisingly there are purpose built devices for this purpose, bars of metal with the ends especially shaped to avoid scarring either the rims or the beads of the tires.


  1. Take the wheel off any vehicle to which it may be attached.

  2. Remove the valve stem cap and open the valve to release the air in the tire.

  3. Break the bead, the raised bit of the tire at the edge of the hole, away from the rim.

  4. Slip one tire spoon between the rubber and the rim at the ten o’clock position and another at two o’clock.

  5. Push down on the spoons in the direction of the center of the wheel to pry the tire wall up over the rim.

  6. Hold one tire spoon where it is and slide the other one along to the point where the sidewall goes back under the rim. Repeat the prying motion to free more of the tire.

  7. Keep going all the way around the tire, until the entire top edge is free.

  8. Attempt to pull the tire upward. If it adheres to the bottom of the rim, flip it over and pry it loose, then turn it back so the free side is up, and pull the tire up so the bottom sidewall is against the top rim.

  9. Place the spoons in the same way as for the top sidewall and work the lower sidewall over the upper rim. Your tire is now free.


Removing a tire from the rim with tire spoons is actually a simple procedure. They are not an expensive tool, but unless you will use them frequently, they may not be worth the investment. It may be possible to borrow spoons from a friend or a discount auto parts store or to rent them. In any case, a set of spoons can help you get old tires off in as short a time as possible.