How to Build Outside Bicycle Storage Racks
Most cyclists are dedicated to their pastime. This dedication can typically mean possession of a myriad of bicycle equipment for the maintenance and repair of their bikes, as well as the likelihood of an almost irresistible desire to collect an extensive sampling of their two wheeled treasures.
Items Needed:
- Screw in utility hooks
- Drill
- Three 6x4 inch pieces of lumber
- Two 3x4 inch pieces of lumber
- Galvanized screws
- Three Lag bolts
- Rubber hosing wide enough to comfortably cover the Utility hooks.
- Scissors
- Sharpie pen
- Ask your local home improvement store cut your lumber to avoid any mishaps or faulty measurements.
- Lay one of your 3x4 inch boards down along the bottom a single 6x4 and construct a ‘T’ by screwing the 3x4 directly onto the bottom of the longer piece of lumber with two galvanized screws.
- Repeat with second set of three foot and six foot lumber.
- Flip both of your newly created wooden ‘T’ sections over. This will enable the three foot cross section to become the bottom base pieces of your rack.
- Place your third and final 6x4 inch board firmly against the top of both inverted ‘T’ sections and attach them together with your screws.
- Hold a utility hook in your hand and run a length of rubber tubing along its curved edge from one end to the other and mark where the end of the hook falls along the tubing with your pen. Cut the tubing along the mark. This will be your master guide for the rest of the tubing. Simply hold the master against the tubing and make a mark where the ends fall. Once you have the tubing marked to match the number of hooks you possess, cut the tubing with your scissors and mount the rubber onto each hook. The rubber will protect your bike rims from any potential scratches.
- Attach your utility hooks into the two inch under section of the six foot cross member of your rack, maintaining a consistent two foot distance between each utility hook and securing tightly to the cross guard as this will be where you attach your bike to the frame.
- Move your rack outside and place beneath an awning or other covered area that will help protect your bicycles from the elements. Mount against the wall using a lag bolt to secure it at each end of the rack and then again in the center.
- Mount your bike to the rack by lifting from the front fork and securing the wheel onto one of the rubber coated utility hooks. Secure the bike to the rack using a typical bike chain.
- Repeat for any remaining bicycles.