Previous Article

The Definition of SAN Storage

Next Article

How to Buy at Auctions of Self Storage Units

How to Build Self Storage

Storage units that are made to fit your specific needs can be your best friend.  These are simply large wooden boxes that have a back on them.  Of course, you can also add a door with hinges in order to make them more secure.

 Things You'll Need



  • 2 pieces of plywood measuring 18-by-60-by-3/4-inch

  • A framing square

  • A variable speed drill with a  1/8-inch drill bit

  • 4 pieces of plywood measuring 22 1/2-by-18-by-3/4-inch

  • A Phillips-head screw tip

  • 1 1/4-inch drywall screws

  • A damp cloth

  • 1 piece of plywood measuring 60-by-24-by-1/4-inch

  • 4-penny box nails

  • Full overlay hinges

  • 1 piece of plywood measuring 24-by-60-by-3/4-inch



  1. Place two pieces of 18-by-60-by-3/4-inch plywood on a flat surface.  Measure from one end so that you can make marks at 3/4, 18 3/4, 19 1/2, 37 1/2, 38 1/4 and 59 1/4 inches. 

  2. Put your framing square on the marks you just made and draw lines across the width of the wood.

  3. Create marks between the lines.  These marks need to be 1 inch from the edges and in the center between the edges.

  4. Use a 1/8-inch drill bit to drill pilot holes on these marks.  This will tell you where the shelves go on the storage unit.

  5. Put the 60-inch pieces together on their long edges so that you can apply glue to the 18-inch edge of the 22 1/2-by-18-by-3/4-inch plywood.  Use 1 1/4-inch drywall screws to secure these pieces between the 60-inch pieces. Take a damp cloth and clean up any excess glue.

  6. Run some glue to the edges of your storage unit.  Put the 60-by-24-by-1/4-inch plywood on the unit.  Use 4-penny finish nails to secure it to the sides and shelves.  Make sure to immediately clean up any excess glue with your damp cloth.

  7. Turn the storage unit over.  The open spaces should now be facing upwards. 

  8. Install the full overlay hinges on your 24-by-60-by-3/4-inch plywood.  Attach the door to the storage unit and secure it with the screws and hinges.

  9. Use 100-grit sandpaper to sand your entire unit. 

  10. Apply a finish if desired.