How to Build Tall Garage Cabinets
Depending on what you need to store in your garage cabinets you may have a difficult time finding a prefabricated unit to suit your needs, particularity if you need a rather tall garage cabinet. If so, there is a simple solution to this problem. Consider building your own tall garage cabinet and you may even save some money.
What You'll Need:
- (2) 3/4 inch plywood 2 feet by 10 feet
- (10) 3/4 inch plywood 2 feet by 2 feet
- (1) 3/4 inch plywood 2 feet 1 1/2 inches by 10 feet
- (1) 3/4 inch plywood 2 feet 1 1/2 inches by 9 feet 11 inches
- Carpenters square
- Drill with screwdriver bit
- Wood screws
- Handle
- (4) Interior hinges
- Construct a rectangle using the 2 pieces of 2 feet by 10 feet plywood and 2 pieces of the 2 feet by 2 feet plywood. These pieces will make up the top, bottom and sides of the cabinet. The top pieces should easily line up with the side edges and the bottom piece should easily fit between the two sideboards with about a 1 inch offset. Once all pieces have been properly fitted, use screws to secure the unit together.
- Install your shelves into the cabinet. You will have nine interior shelves. However, depending on what you plan to store you may not need all of them. Insert your desired amount of shelves leaving approximately 1 foot between each one. Use a screw to secure them into place.
- Take the piece of plywood that is 2 feet 1 1/2 inches by 10 feet and place it on one side of the frame until it covers the entire side. This piece will serve as the back of the cabinet. Ensure that each edge is square and use screws to connect the piece.
- Install the hinges with about 2 1/2 feet in between each one in the inside of the cabinet.
- Connect the last remaining piece of plywood onto the hinges and install a knob. This piece will serve as the door to the cabinet.