How to Build a Flat Roof
A flat roof is going to work wonderfully as long as you build it correctly. If the roof is not built properly, damage and leaks can occur. As long as you have a few of the basic tools and you have some knowledge in roof building, it is going to be extremely easy for you to build a flat roof.
- Using joists, span the gap between two of the walls. Figure out what the maximum span of the joists depending on the load that the roof might have to hold and the span when you are going to be building the roof.
- Using plywood, cover up the joists. Allow for a one eighth inch gap at all of the joints. This is going to let the wood contract and expand.
- Put in noggins between the joists as you are building your flat roof. The noggins are going to help prevent the joists from twisting.
- Before you bring the rubber up for the flat roof, clean the plywood. Take off any debris or dirt off of it that could tear and weaken the rubber.
- Cut off some of the pieces of rubber when the lengths are needed for the flat roof. Cut off about nine inches all the way around.
- Overlap sections of rubber when you lay them down. Glue the seams when you are done laying all of the sheets of rubber. If you are going to need to fit the rubber over any of the pipes, cut out a little hole and slip the rubber over the pipe. Make sure that there is a tight seal around the pipe.