How to Build a Rotisserie Grill
Innovations such as this were born out of necessity by overseas military personnel. It is fairly common to make smokers out of these materials, but not quite as common to build a rotisserie this way. The main difference between the two cooking types is that a rotisserie allows the meat to turn on a spit over a heat source.
Things You Will Need:
- 4-foot length rebar
- 4-inch cutting wheel
- 24 feet of 1 by 2-inch metal bar
- 55-gallon drum
- Bench vice
- Bench grinder
- Measuring tape
- Welding torch
- Ensure that the inside of the drum has been thoroughly cleaned and is free of any residue. These drums tend to hold explosive materials, so it can be dangerous to begin if you skip this step.
- Use your cutting wheel to cut the drum in half lengthwise.
- Set the drum halves aside and measure two 4-foot lengths of steel bar as well as two 2-foot lengths of steel bar. These should be cut to the appropriate length using your cutting wheel. Smooth the cut edges using a bench grinder.
- Position the metal bars flat so that the result is a rectangle. The ends should overlap by about an inch. Weld the pieces together and ensure a sturdy weld by dropping it on the ground and trying to pull it apart. If it holds, set it aside for the next step.
- Cut four more 2-foot lengths of metal bar. Smooth the edges with your grinder. Insert one end of each bar into a bench vice, and bend the bars so that they are in roughly a 45-degree angle. The last inch of the bar should have the bent angle.
- Position your bent bars over your steel rectangle. The bent inch should lay flat against each of the four corners of your rectangle. Weld these pieces together and flip the framework over. It should now stand on the newly constructed legs.
- Place one of the drum halves into the newly constructed metal framework. Weld the steel drum into place. The steel drum now forms a fire pit which can accept a fire source such as wood or charcoal.
- Cut two 3-foot lengths of metal and position them so that they are standing up at the top and bottom of the steel drum half. Weld the bars into place and then make the holders for the meat spit.
- Cut two 2-inch lengths of metal and bend them roughly in half at 90-degree angles. They should then be welded on the 3-foot lengths so that they are about 2 ½-feet above the top lip of the drum.
- Smooth the clean the entire length of a rebar using a bench grinder. Measuring 3-feet from one end, fit the point into a bench vice. Once in the vice, bend the rebar at a 9-degree angle. The result is a 3-foot long spit with a 1 foot long crank, and by bending the crank in half, a 6-inch handle. The finished spit should fit nicely on your holders completing your rotisserie.