Previous Article

How to Turn on the Navigation in a Chrysler Pacifica

Next Article

How to Troubleshoot Chrysler Sebring Headlights

How to Change Chrysler Sebring Brakes

Well working brakes are one of the most important parts of any vehicle. When a car's brakes are not functioning properly, it should not be driven until they are changed repaired. Chrysler Sebring brakes can be changed by a mechanic or at home.

Supplies Needed:



  • Lug Wrench

  • Ratchet

  • Brake fluid

  • Brake cleaner



  1. Drain the brake fluid from the Sebring’s master cylinder. This is located under the hood near the driver’s side.

  2. Use the lug wrench to loosen the nuts on the wheels.

  3. Using a jack, raise the Sebring up off the ground enough to remove the tires and give you plenty of workspace.

  4. Remove the nuts and pull off your wheel.

  5. Replace the nuts back to the tire stud and tighten them so that they keep the disc brake from moving.

  6. Use a ratchet to remove the caliper point pins. Once you have removed the caliper pins then remove the caliper from the mount bracket.

  7. Remove and secure the disc brake.

  8. Remove the brake pads and shims

  9. Use brake cleaner to clean the shims and be sure to put plenty of grease on the back plates.

  10. Put on your replacement brake pads.

  11. Replace the caliper back to the mount bracket and be sure to tighten the caliper pins.

  12. Put on the wheel and tighten the nuts.

  13. Lower the vehicle to the ground.

  14. Pour new brake fluid into the cylinder tank.

  15. Get in your Sebring, pump the breaks several times to properly place the new brake pads.