How to Turn on the Navigation in a Chrysler Pacifica
Chrysler Pacificas come with a pre-installed navigation system that can help you find your way from place to place. The navigation system is convenient and easy to use. The navigation can be started by simply starting the car, pressing a few buttons and typing in name or address of your destination.
- Place the key in the ignition and turn it forward to start the Chrysler Pacifica.
- Locate your navigation screen and press the "Power" button. This button is located near the bottom of the device. You may need to press it once, or hold it in until the device turns on.
- Look on the right side of the device for a button that says "NAV." These letters stand for navigation. Press this button to start the navigation process.
- Select the city, state or point of interested where you would like to go. Start the navigation process and follow the directions that are displayed. The navigation software will give your turn-by-turn directions to get you to your desired destination. You an also control the setting and volume that allows the navigation device to speak the directions.
- When you are finished with the navigation system. Press the "Off" button. Depending on the model of navigation device installed in the vehicle, this button may be the same button you pressed to turn on the navigation. If you forget to turn off the navigation device, the car should automatically turn it off within a certain amount of time. Pay close attention to see if the car does this, if the navigation is left on, it could cause the car battery to go dead.