How to Connect Three Auto Audio Speakers
Connecting three auto audio speakers is straightforward in most cases. Replace the two front factory speakers usually located in the dashboard or doors and replace the rear speaker usually located in the back dash above the back seating area. The three mounting speaker’s height and depth, as well as the vehicles wiring determines the complexity of the installation.
Items Needed:
- Three auto speakers
- Screwdrivers
- Drill with bits
- Wiring harness
- Wire stripper
- Soldering iron and solder
- Connectors and crimping tool
- Electrical tape
- Identify the three speakers that are best suited for your car. Most three-speaker setups include one front left speaker, one front right speaker and one rear speaker or subwoofer with added bass. Select speakers first and note the wattage. You need to know the wattage of the speakers in order to use an amplifier with enough power for the speakers.
- Read the instruction manual that comes with the speakers. The instructions are often vehicle specific, and they give you installation details for your car speakers.
- Select the mounting locations for the speakers. You may need to make minor modifications to make room for speakers that are larger than the factory openings in the car.
- Drill holes in the door panels or the dashboard where you will install the speakers. The bass subwoofer can be installed in the factory speaker location at the rear of the vehicle, but the other two speakers may require custom installation in the doors or dashboard.
- Remove the grilles on the dashboard to take out to the old speakers, or remove the door panels to access the two speakers in the left and right doors. Remove the screws holding it using a screwdriver and note the polarity of each terminal as you remove the speakers.
- Attach the new speakers using a wiring harness, or by soldering the connection. This will depend on the installation requirements of the particular speakers.
- Attach the wiring harness to the new speaker’s terminals making sure the polarity is correct. Plug the other end into the factory harness. Crimp or solder the connections if necessary. Test the speakers before you re-attach the dash grille or door panels.