How to Construct a Leach Field
A leach field, which is commonly referred to as a septic drainage field, is a group of perforated pipes that are laid out in underground trenches filled with gravel or rocks. The field is used to remove impurities or contaminants from the liquid that is released from the septic tank. Constructing a leach field is something you can easily do yourself.
How to Construct a Leach Field
- Check with your local health department to find out if a permit is needed to construct the leach field.
- Determine where the leach field is going to be located and perform a soil test to determine its absorption capacity. The Department of Agriculture will perform the test for a fee. Avoid placing the field in an area that has poor drainage. The drain should be approximately 10 feet from the home and any gardens on the lawn.
- Use a shovel to dig the trenches for the field. The trenches should be approximately 3-feet wide and 3-feet deep. Make sure that there is at least 100 feel of leach field for a 1000-gallon septic tank, which can be accomplished by constructing four 25-foot trenches or two 50-foot long trenches. The trenches should also be slanted downward at no more than 1/4-inch for every 8-feet of pipe. Too much of a slant could cause drainage problems.
- Place a layer of gravel or rocks in the trench, which should be approximately 1 1/2-feet deep.
- Lay the perforated pipe on top of the gravel and connect it to the septic tank drain.
- Place 1/2-inch of gravel on the top and sides of the pipe.
- Lay a thin cloth down on top of the gravel to prevent dirt from getting into the rocks.
- Replace the dirt that was previously removed to dig the trench.