Previous Article

Top Satellite TV Companies

Next Article

How to Recycle a Satellite Dish

How to Extend Satellite TV Cables

The installation of a satellite dish for satellite television viewing is not necessarily a complicated or difficult process, but it does require precise logistics. A coaxial cable is used to connect the home's satellite dish to the television receiver. If the cable is not long enough, it will have to be extended for proper signal transferral.

Satellite cable television services use an RG-6 quad shield coaxial cable for the conduit of their signal. This kind of cable is very durable and built to be capable of blocking the most noise and interference. Depending on a homeowner's particular setup, the cable may not be long enough to reach between the dish and the receiver. If this is the case, follow the simple instructions to extend the satellite cable.


Items Needed:




  • RG-6 quad shield coaxial cable

  • Male to male 3-Ghz rated coaxial connector

  • Coaxial extension

  • In-line satellite amplifier (optional)



Instructions:



  1. Take the male to male 3-Ghz rated coaxial connector and insert it into the RG-6 quad shield coaxial cable that is in need of extension. Be sure to put it into the female end of the coaxial cable. Pressing the ends together will allow the threads to mate and secure properly.

  2. Take the connector and screw it into the cable in a clockwise motion until it is secure.

  3. Insert the coaxial extension into the connector's free end. Screw the cable until the fit is secure.

  4. Take the coaxial extension connector and screw it into the input of the decoder box that is labeled "SAT." This should be found in the back of the box.


Tip:



  • If the distance that you need to extend the coaxial cable runs more than 100 feet, substitute an in-line satellite amplifier for the male to male connector. The amp will be powered by a small level of current from the satellite's low noise blocker.