Previous Article

How to Extend a Downspout

Next Article

How To Extend a Pool Liner

How to Extend a Downspout Under the Ground

Downspouts are essential to a home. They are used to drain water away from a house to keep it from enduring water leaks in the home, basements and crawlspaces. If you extend a home's downspout under the ground it allows the water to flow away enough from the home to keep the water from building up. If the pipe is extended the water flows below the ground's surface.

Items Needed to Extend a Downspout Underground:



  • Wooden stick

  • Shovel

  • Paint

  • Perforated pipe

  • Landscaping fabric

  • Rope

  • Utility knife



How To Extend a Downspout Underground:



  1. Take a wooden stick and put it in the ground nine feet away from your downspout. Take a ripe, tie it to the downspout, run it to the stake and tie it. Paint a line under the rope line on the ground with spray paint. Remove the rope.

  2. Remove the sod items and keep them to use later. Begin digging your trench with the shovel. Dig your trench along the line of the spray paint mark. Make the trench two feet deep and two feet wide.

  3. Tie the rope around the downspout again, take your stick and put it at the end of your trench. Tie the rope to the top of the stick so it is a tight straight line. Measure the total length of the stretched rope and lower the on the rope about one inch for every foot of the rope.

  4. Make sure your trench is dug deep; at least two feet of clearance should be between the bottom of your trench. This is imperative to allow the pipe to slope downward as it moves away from the house. 

  5. Lay out your landscaping fabric. This should be placed along the bottom of your trench. Take a utility knife and cut it to the right size. Put stones and rocks into your trench. There should be at least a 3-inch layer over the fabric. Level out all your rocks and stones. 

  6. Put a perforated pipe at the bottom of the trench. One end of the pipe should be below the bottom of the downspout and the other at the end of the trench. Install a curved adapter into the end of the pipe to go up under the downspout. 

  7. Take the measurements of the length of additional downspout needed to reach the pipe. Use a hacksaw to cut it. Add the new piece to the existing downspout using an pipe adapter. Use a screwdriver to make sure the screws are tight and secure. 

  8. Put the extended downspout on the open end of the adaptor. Tighten the set of screws to link all the pieces together securely. Make sure they are screwed tightly.