Previous Article

How to Frame a Casement Window

Next Article

How to Remove a Double Casement Window

How to Glaze a Casement Window

Casement windows have a glaze on them that can be used as a tint. After some time, the window glaze can become cracked or start to look dull. You can replace the glaze on your own with the right tools and by following the right steps.

1. Start your window glazing project before the cold and rainy season. The glaze putty in the encasement will act as an insulator and will help keep the cold out. It can also help keep any water out when there is a lot of rain beating at your window. The putty also helps to keep the heat out, but your project can be done during the hot season with no problem.


2. Remove the old putty before starting to reglaze your window. The old putty is the cement-like material that is in the lines of the frame. Using a heat gun, heat a section of the putty and use a putty knife to pry it out. Continue doing the same around the entire window until all the putty has been removed.


3. Prepare the wood for the new glaze. Use primer to coat any bare wood on the frame.


4. Place the can of putty into a pot or warm water to soften it up a little. This will make it easier to spread. Using a putty knife, knead the compound so that it is soft.


5. Apply the compound where the window glass meets the casement. You can either use your putty knife to spread the glaze putty into the seams or you can use your fingers.


6. Smooth out the compound using a putty knife. Make sure that the putty fills the seam completely and that there are no air pockets or bubbles in your putty compound.


7. Use the putty knife to push back any putty that has crept onto the glass, making sure that the putty is straight.


8. Allow the compound to set for a few days.