How to Install Aluminum Windows
Installing aluminum windows isn't an easy do-it-yourself job. If you do not have the correct tools or knowledge, you window can leak causing a lot of damage to your home. You will need some basic carpentry skills and math skills to install or replace an aluminum window.
Supplies
- Aluminum window
- Tape measure
- Damp cloth
- Spray adhesive
- Flashing
- Sill pan
- Plastic screen drain
- Nails
- Hammer
- Level
- Sealant
Directions
- Check the new window to make sure there are no cracks. Bent corners can be bent back in place with a pair of pliers. Double check the measurements to ensure the window will fit.
- Make sure the window is square. Do this by measuring from the top right corner to the bottom left. This measurement should be the same as measuring from the opposite corners. If it is not square, it will not fit properly into your home.
- Remove the window from the packaging material and clean with a damp cloth to remove and dust from storage.
- Check to make sure the window lock works and keep the window in the locked position for installation.
- Spray edges with an adhesive, but do not let overspray get on window pane.
- Attach a three inch square piece of flashing to the top two corners.
- Cut the sill pan to the size of the window opening plus one inch. The sill pan prevents water from sitting in the window opening causing damage to the wood and siding.
- The rough opening of the window should be 1/2 to 3/4 inch longer and wider than the window frame. It should be level, plumb and square. It should be double studded to provide more support for the window.
- Place your sill pan into the rough opening. Spray adhesive 3 inches from the edge of the sill pan and along the sides.
- Apply self-adhesive flashing at the corners of the sill pan and to the sill. Then install the plastic screen drain.
- Make sure window is facing the right way before installing. Place the window inside the rough opening. Secure window in place with nails at the nailing fin. Do not drive nails completely down yet; make sure the window is plumb and square and then drive down all nails.
- Apply sealant to all sides to seal window and prevent air and water leaks.
- Attach nail drip cap to the header. Spray nailing fin with spray adhesive. Apply flashing and replace siding over the flashing.