How to Install Marble Tiling
One of the most beautiful types of tile is marble. It has been used in many earlier designs to enhance the appearance of buildings and structures. Today it is still captivating and available in many textures and colors to allow a homeowner to heighten the look of a room. It should be installed properly because mistakes can be hard to remedy.
Materials Needed
- Broom or vacuum cleaner
- Water and cleaner
- 1/2 inch backer board
- Skilsaw
- Galvanized screws
- Latex fortified mortar
- Trowel
- Fiberglass tape
- Marble tile
- Sealer
- Thinset mortar
- Tile spacer
- Wet saw
- Tile cement
1. Clean the floor of any dirt and debris with a broom or vacuum cleaner. Clean the floor with water and a cleaner. Allow the floor to completely dry.
2. Install backer board to the floor. Use ½ inch backer boards. Use a pencil to mark cuts on the backer board. Use a level to help you create a straight line. Cut the backer board with a silksaw. Fasten the boards to the floor with galvanized screws. Make sure the seams of the backer board match the seams on the floor.
3. Apply latex fortified mortar into the seams with a trowel. Apply fiberglass tape over the joints and seams. After the tape has cured, apply a layer of the latex fortified mortar over the tape. Allow the area to dry.
4. Place the marble tile on the floor to review how it will look after you install it. Arrange them so you will also know where to cut it.
5. Apply a stone sealer to the marble stone before you remove it. The sealer will protect the marble tile after it is installed because it accepts stains easily. Remove the tiles after the sealer has dried. It is better to begin installing the tile from the middle of the room.
6. Use a notched trowel to apply a small amount of thinset mortar. Lay the tile into place. Slide them into place and press them. Remove any excess mortar before it dries as you go along. Tile spacers should be used to help you keep the tiles in a straight line. Continue installing the tile until the entire floor is complete. Use a wet saw to cut any tile near the walls. Allow the mortar to dry for 24 hours.
7. Apply another coat of sealer before applying the tile cement. Fill in the joints with tile cement. Allow the sealer and tile cement to sit for one day.
8. Go over the floor with a damp sponge to clean away any haze from the marble tile.