Previous Article

How to Fix Shower Plumbing

Next Article

How to Replace PVC Plumbing for Bathroom Sinks

How to Install Shower Plumbing

Installing plumbing for a shower is a fairly easy project for someone with general plumbing knowledge. Before starting any plumbing project, one must ensure that the proper local codes are met. In some areas, a building permit may also be required.   

 Items Needed:



  • PVC pipes

  • Primer

  • Plumber's putty

  • Drill

  • PVC cement



  1. Check with the local building department. Make sure that all codes are met  before starting the plumbing project. Also inquire if a building permit is needed.

  2. Shut off the main water supply in the home. Once this has been done, open all faucets so that all remaining water is drained from the water system.

  3. Determine which type of drainage pipe will be used. There are two types of drainage pipes available: a P-trap and an S-trap. The P-trap should be used when the waste water drains on the sides of the wall. If the wastewater will be drained underneath the shower, then the S-trap needs to be used.

  4. Install the drain. Attach the shower drain to the main drainage system in the house. The location of the main drainage system will vary depending on the original plumbing set up in the home. 

  5. Align the plumbing. Drill a hole in the shower and connect the PVC hardware to the existing plumbing. Smooth out any rough edges. Apply primer to the PVC hardware, as this will aid in cohesion and also prevent potential leaks. Make sure that all the pipes fit properly before securing the pipes in place with the PVC cement.

  6. Attach the drain cap. Apply a generous amount of plumber's putty to the drain cap. Screw the drain on by hand and make sure that it is tightly secured. The shower is now ready to be installed.