How to Install Tile Around a Kitchen Island

Updating your flooring with tile is a popular option in kitchen remodeling projects. However, there can be some special challenges if your kitchen has an existing island. Tile must be applied up to and around the cabinet island, and finished with grout.
Supplies

- Cement board 1/2-inch
- Power screwdriver
- Trowel
- Chalk line
- Tile
- Grout spacers
- Thin set mortar
- 5-gallon bucket
- Drill
- Drill mixing paddle

- Level
- Wet saw
- Grout
- Grout float
- Water
- Sponge
- Caulk
- Caulking gun
- Molding
- Nails
- Cover the floor with cement board. The board should not flex when you walk over it, or cracks in the tile occurs.
- Screw the cement board to the floor using a drill and screws.
- Use a chalk line to layout the design of the tile on your floor. This will help keep the lines straight when laying the tile.

- Check the design layout with several of the actual tiles and spacers to see if the design is the right one.
- Use a bucket to mix up the thin-set mortar. The mortar should be slightly less stiff than peanut butter.
- Apply a 1/4-inch layer of mortar over the entire cement board floor. Use a trowel for this step, to smooth and remove any material.
- Apply mortar to the backs of tile blocks with the trowel. Place the tile into position on the floor and firmly press into place. Lay a level on it to make sure the tile is flat and even.
- Whole tiles must be installed first. Use tile spacers to guarantee a uniform space between pieces. Trim tiles to fit around your walls and borders of your island with a wet saw.
- Allow the mortar to dry for 48 hours.
- Use a bucket to mix grout. Apply a layer of mixture to the lines in the floor with a grout float.
- Immediately clean off any grout on top of the tile. Ask an assistant to help with this part, because hardened grout is very difficult to remove from tiles. Therefore, it is important to remove it as quickly as possible. Use a clean sponge to remove the grout while damp.
- Allow the grout to dry for 24 hours after application.
- Use a caulking gun between the cabinet edges and baseboards. Apply a decorative molding over the caulking with nails around the kitchen island.