How to Install a Badger Garbage Disposal
For a lot of people a garbage disposal is a necessity and helps to maintain a clean area when it comes to food preparation and cooking. Garbage disposals work not only to help keep the kitchen clean, but also sanitary. A very popular brand of garbage disposal units is Badger. To get adequate use of your Badger garbage disposal you must make sure that you install it properly.
Items Needed:
- Badger garbage disposal
- Pipe wrench or pliers
- Screwdriver
- Wire nuts
- Plumber’s putty or sealant
- Power supply cord
- Shut of the power to the garbage disposal's receptacle by flicking the switch at the circuit box.
- Loosen the large nuts connecting the sink drainpipe to the P-trap and the skink's strainer flange using a pipe wrench or pliers. Carefully remove the drainpipe and the flange. Clean off the sealant or old plumber's putty from the sink fitting.
- Put silicone sealant or plumber's putty over the top drain opening. Press the new Quick-Lock sink flange into place. Slide the gasket and mounting rings over the bottom of the flange and use a screwdriver to tighten the tree mounting bolts to secure the assembly in place in the sink.
- Expose the wires at the bottom of the disposal by unscrewing the access assembly screw. Twist together the white, black, and green wires with the corresponding wires from the power cord by using the wire nuts. Replace the panel and make the same connections in the junction box to the power supply with the wires.
- Use the slots in the mounting ring to match three mounting tabs on top of the disposer. Lock the taps into place by turning the mounting ring.
- Take the gasket supplied with the disposal and slip it over the discharge shoot opening. Use the factory screws to connect the discharge tube to the P-trap. Use pliers or pipe wrench to tighten the large nuts.
- Turn the power back on to the junction box. Make sure there are no leaks by filling the sink with water and turning the switch to the garbage disposal.