Previous Article

How to Clean a Rubber Roof

Next Article

How to Lay a Rubber Roof

How to Install a Rubber Roof Membrane Around Posts

When it comes to traditional roofing methods, damage and leaks will eventually happen. This is caused by inflexibility, leaks, and failing joints. A rubber which can help prevent this type of problem is ethylene propylene diene monomer (EPDM). It is lightweight and very durable. This type of rubber is UV resistant and doesn’t need much repair. It can be installed without professional service with proper tools.

Supplies:



  • Measuring tape

  • Chalk

  • EPDM adhesive

  • Seam tape

  • Roll of EPDM rubber

  • Roof cleaner



  1. Prepare the surface of the roof by rinsing off loose dirt and debris. Then apply roof cleaner.

  2. Take the EPDM rubber and unroll it. Let it flatten for 30 minutes so the material will be relaxed and easier to use.

  3. Take some measuring tape and determine the diameter of the top and base of the metal posts. This will give the size of the holes needed to cut in the rubber.

  4. Take measurements of the rooftop’s surface area. Take some scissors and cut sections of the rubber in manageable sizes. Take some chalk and draw the bigger of the two post diameters on the rubber.

  5. Use some crosshairs to show the diameter. Then draw a complete circle.

  6. Use an application brush to stir the can of neoprene liquid adhesive for five minutes. Fold back the sections of the rubber and put it on the backside and surface of the roof to reinforce the bond.

  7. Press the EPDM sheet over the posts and on the surface of the roof. Flatten air bubbles and wrinkles with a push broom or roller.

  8. Use some seam tape for the spaces between the sheets of rubber. Let the EPDM rubber cure in a dry climate for 48 hours.