How to Install an Oriental Rug Pad
One of the most important and overlooked steps in adding an oriental rug to a room is installing an appropriate rug pad. A good pad will extend the life of the rug and protect the floor underneath it. Because these pads are relatively inexpensive and simple to install, you can easily add one to your rug.
Materials
- Foam or fiber rug pad appropriate for your floor type
- Tape measure
- Straightedge
- Shears or razor knife
- Broom and dust pan
- Floor cleaner for your floor type
- Rags or mop
- Paper and pencil
Procedure
- Find the dimensions of your rug. If it is a new rug, you can find this information on the package. For an older rug, measure it to obtain the length and width. Write the measurement on a piece of paper for reference.
- Move furniture away from the area where you will lay the rug. If your oriental rug is already on the floor, roll it loosely, and remove any padding underneath. Discard the old padding, and put the rolled rug aside.
- Sweep the area under the rug, and clean the floor with the cleaner and rags or mop. Let it dry completely before you place the pad or the rug. Dirt or particles under a rug can scratch the floor, and water can warp or damage it.
- Size the rug pad. You need a pad that is a half an inch to two inches smaller on each side than your oriental rug. If your pad is already an appropriate size, skip to step 6. If the pad is too large, go to the next step. If the pad is too small, you need to return it for one that is an appropriate size.
- Use the straightedge and shears or knife to cut the pad so that it measures a half an inch to two inches smaller than the rug.
- Lay the pad in the center of the area where you will place the rug. Keep in mind that the actual rug is slightly larger than the pad.
- Center the rolled oriental rug on the rug pad, and unroll it carefully. Adjust as needed so the pad does not show.