How to Make Barbecue Grills Out of Drum Barrels
Constructing a grill out of old drum barrels is not too difficult. You will end up with a pretty good sized barbecue grill that you made yourself. You will need to find a 55 gallon drum barrel. Be sure that the one you choose was not used to hold any chemicals or poisonous products. Look for one that was used for food products, like vegetable oil. You can also look online to buy a new one.
Supplies:
- Drum barrel
- Jigsaw with blade for cutting metal
- 2 hinges
- Metal handles with nuts and bolts, you can use one or two. This will be to open and close the grill.
- Newspaper, kindling wood and matches
- Metal drill
- Metal grate
- Grill plate
- Screws
- Metal table, about the same size as the drum and a height that is comfortable for cooking
- Pencil
- 4 metal angle brackets
Directions:
- Using the jigsaw, cut the drum in half lengthwise. Cut as straight across as possible. One side will be the grill. The other half can be used for a cover or a second grill. If you have experience, a plasma torch is an easier way to cut the barrel.
- Use the metal file to file down the edges on the barrel. Be sure you do not leave any sharp or jagged parts.
- Put newspaper and kindling in the barrel, light it with matches. This will cure the drum and at the same time, you are getting rid of any residue from the previous substance that the drum held.
- Once the drum cools, rinse it with water.
- Place the drum with the open side facing up, on top of the metal table. Drill four holes, one in each corner through the drum and into the table. Use nuts and bolts to bolt the drum to the table.
- Drill two small holes in the bottom of the drum, one on each end for ventilation.
- If needed, cut the metal grate so that it will fit in the drum. It should sit about 2 inches up from the bottom. The charcoal will go on this grate.
- Place two angled brackets on each side of the drum. Mark holes for placement with a pencil before pre drilling holes. Once holes are drilled, use screws to attach. These brackets will hold the grilling grate.
- Place the grilling grate on the brackets.
- Using the hinges, mark where the drill holes should be in the cooking half of the barrel and the upper half of barrel. Attach hinges so lid opens and closes.
- Drill holes and use screws to attach handle on the front of the grill cover.
- Your grill is now ready to use, unless you want to paint it. If you would like to paint it, choose a high temperature paint made for grills, such as Char Broils grill paint.