How to Make Cheap Solar Cells Out of Aluminum
Using solar energy can save you money because you do not have to pay anything for it. You do not have to worry about wasting fuel or using harmful products when utilizing it. The best way to cut fuel and electricity cost is by building your own solar cells from aluminum.
Materials Needed
- Tape measure
- Cardboard
- Utility knife
- Aluminum flashing
- Tin Snips
- Pencil
- Duct tape
- Silicone caulk
- Drill with ½ inch drill bit
- Plastic sheeting
- Use a tape measure to measure your window. Make sure you add 5 inches to each size you measure. Place a large piece of cardboard on a flat surface. Trace the measurements out on the cardboard using a pencil.
- Cut the cardboard using a utility knife. Place a piece of aluminum flashing on a flat surface. Use the cardboard as a guide to cut the flashing the same size. Use tin snips to cut the aluminum to size.
- Measure a 5-inch square on each corner of the cardboard and the aluminum flashing. Cut the squares out of the cardboard with a utility knife and out of the aluminum flashing using tin snips.
- Bend both sides of the cardboard to form a box. Use duct tape to hold the cardboard together. Fold the aluminum flashing into a box. You do not need to use tape on the aluminum because it should stay in place.
- Take silicone caulk and place it along the joints inside the cardboard box. Place the aluminum inside the cardboard box. Press the aluminum flashing to make sure it is secure. Allow the silicone caulk to dry for 24 hours.
- Use the tin snips to cut four sections of aluminum flashing. The flashing should be the same depth as the box and as wide. The width of the flashing should be half of the width.
- Place silicone caulk around the left edge and back edge of the first piece of aluminum. Take the first piece and place it on the left area of the box. Make sure the piece is 10 inches from the top edge of the box. Caulk the next three pieces also. The pieces should fit around the top edge of the box. Allow the silicone caulk to dry for 24 hours.
- Have plastic sheeting precut at your local home improvement or hardware store. Place silicone caulk on the front edges of the cells and along the front edges of the flashing. This is where the plastic sheeting will fit. Press down on the sheeting to make sure it is in place and allow it to dry for 24 hours.
- Use a drill with a ½ inch drill bit to drill holes on the box. Drill six holes on the top. Turn the box over and drill six holes on the bottom. The holes on the bottom will take in cool air. The holes on the top will allow warm air to escape. Put the aluminum solar cell in a window that faces south.