How to Make PVC Plumbing Solvent Connections
PVC pipe is popular for home improvement and construction uses, because it is highly affordable and easy to install. Unlike copper pipes, which need a soldering torch in order to fit pipes together properly, PVC pipes only need fittings, cleaner and glue.
Items Needed:
- Tape measure
- PVC pipe
- PVC fittings
- PVC cutter
- Permanent marker
- File
- Clean rag
- PVC cleaner
- PVC glue
Instructions:
- Determine the length of the PVC pipe that you plan on installing.
- Mark the appropriate length on the PVC pipe with the marker and cut the pipe with the PVC cutter.
- Use the file to remove any bur left on the edge of the PVC pipe and wipe the edge clean with a rag.
- Clean at least 1 1/2 inch of the edge of the PVC pipe with the PVC cleaner. Use the brush that is attached to the PVC cleaner lid. Be sure to dip the brush back into the PVC cleaner if it becomes dry.
- Clean the interior of the fitting that will attach to the PVC pipe with the PVC cleaner. Make sure the inside is entirely coated with cleaner.
- Apply PVC glue to about 1 inch of the cleaned PVC pipe edge.
- Apply PVC glue to the inside of the fitting. Be sure that you only apply glue on the fitting to the side that will be attaching to the cut PVC pipe edge.
- Insert carefully the PVC pipe to the fitting. If enough glue has been applied, an excess amount will ooze out a bit from the connection. This is not a problem. Hold the pipe and fitting firmly together for at least 20 seconds in order to give the glue time to set a bit. Once you can release some pressure on the hold without the pipe pushing out from the fitting, you can release your hold entirely and allow the glue to set completely.