How to Measure for Replacement Casement Windows
The first step in replacing your casement windows is to obtain measurements. Because of the shape of the openings this can seem like a difficult task, but it really isn't. With a few simple tools you can measure the windows successfully.
Supplies
- Tape measure
- Claw hammer
- Pad
- Pencil
- Pull out the nails around the trim of the window with the claw hammer. Remove the trim by hand as you loosen the nails in each piece. Set aside.
- Remove any insulation under the trim until you can see the actual sides of your casement window frame.
- Measure the height on both sides and in the middle of the exterior portion of the window. Calculate the measurements from inside the frame, so it is not included with your measurement. You must measure each window individually because there could be slight variations in sizes. This is especially important if the windows are installed in an older home.
- Measure the width of the window across the top, middle and bottom, again inside of the frame.
- Measure the depth of the window from the outer edge up to the bottom of the sill.
- Write down all measurements.
- Repeat the same procedure for the indoor face of the window. Since casement windows in older homes were handmade, there are usually variations in the measurements.
- Purchase your new window based on your figures. Always use the smaller of the recorded measurements. New window units can be shimmed to ensure a proper fit.