Previous Article

How to Fix an Electric Boat Horn

Next Article

DIY House Boat Plans

How to Mount an Electric Boat Winch

An electric winch will be a lot easier to use than a hand cranked winch. These winches might be more expensive, but your body will thank you. It takes a lot of effort to manually crank a boat out of the water.

Things you'll need:



  • Nuts

  • Bolts

  • Wrenches



  1. Have someone hold the electric winch where you want to fasten it. Step back a few feet and inspect it. Make sure this is exactly where you want to mount it. The best place to mount the new winch is probably where the old hand crank winch was located.  

  2. Insert the bolts that came with the new winch into the frame holes. You'll probably need someone to hold the winch in place again so you can easily push the bolts through the holes.

  3. Screw nuts to the back of each bolt and finger tighten them. You don't want to completely tighten the nuts just yet. 

  4. Test the winch by plugging it in and move the cable back and forth. Don't try pulling anything because the nuts are only finger tightened. Trying to pull something could cause the winch the rip off the frame. You're only testing to make sure it powers up and moves properly.

  5. Tighten the nuts to the frame with a couple wrenches. Hold one wrench on the nut while turning the bolt with the other wrench. You might need someone again to hold one of the wrenches if they're in awkward positions. You should now be able to enjoy your new electric winch.