Previous Article

How to Make a Homemade Motor Boat

Next Article

How to Repair a Bent Propeller on a Motor Boat

How to Operate an Outboard Motor Boat

Outboard motor boats normally run on a manual pull start system, with gearshift controls, a throttle and a tiller to steer the boat. The ability to properly run an outboard motor smoothly without causing damage requires cautious attention to several important details.


  • Start up the engine by pushing the release lock on the main throttle and shifting it vertically to neutral position.

  • If the motor has not been started for some time, the choke knob will need to be pulled out to readjust the ratio of fluid and air in the combustion chamber. If the motor is used regularly, the choke is not necessary unless the motor does not start up in a few minutes.

  • Adjust the throttle lever to the start position.

  • Locate the starter rope and tug on it forcefully to its full capacity until the engine starts up. Do not stand up in the boat during this process because you may lose your balance when the outboard engine roars to life.

  • Readjust the throttle control to its run mark and grasp firmly on the throttle/tiller. This is the main control now in directing the boat through the water.

  • Be mindful of traffic, and start out at a slower pace until you feel comfortable. Keep in mind that whichever way you turn the throttle; the boat will turn in the opposite direction because the throttle controls the stern of the boat, not the front.

  • The shift lever adjusts the direction of the boat to forward or reverse as you make your way through the water.